Adding Tooling - 5/32" router cutter to VR2
Posted: Tue 10 Apr , 2007 15:30 pm
I went thru VR Milling V2 and found how to add tooling to the Tooling Library.
Click on the Help tab
Click on VR CNC Milling
Click on the Index tab
Type in tooling
Double Click on adding a new tool – under the heading Tool Window Library
In VR Milling V2 – ( Units should be in Inch )
Open the Tooling Library and scroll to the bottom
Right click on the last little colored oval
Left click on Add Tool
Type in 5/32” Router and then <enter>
Click on the + to open the tool info
Click on any of the tool info to open the Tool Data window
Highlight and type in the tool data
Dia. 0.1562
Length 2.000
Offset 0.000
Flute 0.4375
Click OK
If the picture next to it is not a slot mill
Right click on the picture and select Slot Mill
Open the Tooling window
Right click on 1
Highlight Insert
Scroll down to and click on 5/32” Router
Click on the Help tab
Click on VR CNC Milling
Click on the Index tab
Type in tooling
Double Click on adding a new tool – under the heading Tool Window Library
In VR Milling V2 – ( Units should be in Inch )
Open the Tooling Library and scroll to the bottom
Right click on the last little colored oval
Left click on Add Tool
Type in 5/32” Router and then <enter>
Click on the + to open the tool info
Click on any of the tool info to open the Tool Data window
Highlight and type in the tool data
Dia. 0.1562
Length 2.000
Offset 0.000
Flute 0.4375
Click OK
If the picture next to it is not a slot mill
Right click on the picture and select Slot Mill
Open the Tooling window
Right click on 1
Highlight Insert
Scroll down to and click on 5/32” Router