Denford Software & Machines

Posted: **Thu 29 Mar , 2007 1:19 am**

I just inherited 12 Denfords. All pretty much brand new, and I could use some help. Firstly can anyone tell me how to update my Micromill Integrator. I have the the @ 97 software and i would like to get it to a more 3dish view. All the mills are about 10 years old and they have allthe original software.

Any help would be appreciated.

Posted: **Thu 29 Mar , 2007 8:55 am**

I'm guessing its the DOS software you have ?

I'm not sure what control was fitted to a Micro machine in 1997, but guess it would be a Smartstep ?
Can you take a look at this PDF
https://www.denfordata.com/projectimages ... _guide.pdf

It should answer your question, and confirm to us what control(s) you have.