VR Milling 2.31 Password recovery
Posted: Wed 28 Mar , 2007 13:45 pm
How do I recover the necessary password to access 'Setup Machine Parameters'?
Denford Software & Machines
Welcome to the Denford CAD CAM CNC forum
https://www.denfordata.com/bb/
VR Milling 2.31 Password recovery
Page 1 of 1
Posted: Thu 29 Mar , 2007 7:31 am
If you have not changed it from the default then it is "denny" (without the quotes). If was changed then Admin will be able to to post some information
Posted: Thu 29 Mar , 2007 9:02 am
If the password has been changed, then I can only advise on how to recover it by private message, or email (technical at(@) denford dot co. uk)
Otherwise, it defeats the whole point of having a password, if everyone knows how to reset it
Otherwise, it defeats the whole point of having a password, if everyone knows how to reset it