Microrouter is cutting smaller by a factor of 10
Moderators: Martin, Steve, Mr Magoo
-
bradders
- CNC Guru
- Posts: 1251
- Joined: Mon 13 Feb , 2006 12:35 pm
- Location: Brighouse, England
- Contact:
Microrouter is cutting smaller by a factor of 10
My Microrouter is cutting smaller by a factor of 10 any idea's ?
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
If a machine is found to be moving 10 times too much, or 10 times too little, then its because the wrong machine is selected in the software.
Eg, The machine has microstepping drives, but the software thinks it is normal stepping, because the wrong machine variant is selected, so outputs 10 times too few step commands.
There is some confusion with VR Milling 2 where a
RouterProNS is not a microstepping machine
RouterV5ProNS is a microstepping machine
Eg, The machine has microstepping drives, but the software thinks it is normal stepping, because the wrong machine variant is selected, so outputs 10 times too few step commands.
There is some confusion with VR Milling 2 where a
RouterProNS is not a microstepping machine
RouterV5ProNS is a microstepping machine