Hi all
I have loaded a model (.fnc) and trying to set the work piece offset but not having any look.
Attached a video for you to see.
Trouble with 1st run
Moderators: Martin, Steve, Mr Magoo
-
Suggy
- Posts: 24
- Joined: Thu 09 Jul , 2020 0:20 am
- Hardware/Software: DesignSpark Mechanical (not too bad with it)
Fusion360 Trying to get to grips with it
Microrouter v4 (still learning) - Location: Wakefield, UK
Trouble with 1st run
- Attachments
-
- Not going to datum set possition.rar
- (5.36 MiB) Downloaded 915 times
-
Suggy
- Posts: 24
- Joined: Thu 09 Jul , 2020 0:20 am
- Hardware/Software: DesignSpark Mechanical (not too bad with it)
Fusion360 Trying to get to grips with it
Microrouter v4 (still learning) - Location: Wakefield, UK
Re: Trouble with 1st run
Turns out it only happens in VR mode