Page 1 of 1
machining a bezier curve
Posted: Wed 01 Feb , 2017 11:58 am
by rpj1955
i am trying to cut a simple spiral from a bezier curve. although vr milling shows the correct path when selected the outcome is nothing like the original. see attached pics
Any ideas?
Re: machining a bezier curve
Posted: Thu 02 Feb , 2017 12:12 pm
by Denford Admin
Hi. When the DXF file is imported into the latest version, 5.64, the output path appears to be followed correctly.
- bezier.jpg (116.52 KiB) Viewed 13139 times
This is produced using a single 'Follow Cut' path. Can you try the latest software version please?