Page 1 of 1
Motor drives
Posted: Thu 24 Sep , 2015 11:20 am
by malcolm1942
Having trouble with Drive on CNC 3 (1986) Had two boards repaired But the fuses keep blowing on the motor drive board. Any suggestions. Display says Motor Drive fault in 'x'
Re: Motor drives
Posted: Thu 24 Sep , 2015 15:17 pm
by Martin
Can you post some pictures please? Not sure what a CNC 3 is!
Re: Motor drives
Posted: Fri 25 Sep , 2015 10:11 am
by malcolm1942
RThanks for the reply. Camera not working at moment. It is the Easymill 3 CNC. It is behaving similar to Ollies query. red lights on the only board that is working, which incidentally does work in the other two slots on the board.
Re: Motor drives
Posted: Fri 25 Sep , 2015 10:19 am
by angel-tech
sounds like cd20/30
ps. make sure you turn the power off before removing or connecting the drives.
Re: Motor drives
Posted: Sat 26 Sep , 2015 20:52 pm
by malcolm1942
THANKS. ONE DRIVE WORKING IN ALL THREE SLOT OTHER TWO SHOWING RED LIGHTS.
Looks like two duff ones. Any ideas.