i have found mastercam version 6.13 as well as a registration disk from denford labeled 'microrouter post for mastercam'.
1) there does not seem to me anything about microrouter post on the denford software downloads - is it out of service?
2) is master 6.13 a useful program?
microrouter post for mastercam
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: microrouter post for mastercam
MasterCAM was pretty good. I've only ever seen it used by someone else, but it looked very capable.
Imagine its bit dated and difficult to use by today's standards.
It'll still do all the things you need a Microrouter to do, if you can get to grips with it.
Imagine its bit dated and difficult to use by today's standards.
It'll still do all the things you need a Microrouter to do, if you can get to grips with it.
-
papa_dogo
- CNC Apprentice
- Posts: 38
- Joined: Sat 08 Jun , 2013 0:54 am
- Hardware/Software: microturn/vr turning/lathecamdesigner
micromill/vr milling
Re: microrouter post for mastercam
any idea what the 'microrouter post for mastercam' disk is?
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: microrouter post for mastercam
I think it will be a file which can be plugged in, or somehow added to the MasterCAM installation so that the Microrouter machine will appear as a post-process output option. This file will tell MasterCAM how to create gcode which will run on the Denford machine.
There are other post files for MasterCAM here:
viewtopic.php?t=667
There are other post files for MasterCAM here:
viewtopic.php?t=667