starting a milling program from its mid point
Posted: Thu 06 Jun , 2013 12:49 pm
Good afternoon,
i have started a rather long program on the VR milling V5 software - im using the router 2600 pro.
is there a way i could stop the program and restart it tomorrow from its last position? the computyer will automatically if i leeve the pc it will automaticall shut down.
many thanks
Mark
i have started a rather long program on the VR milling V5 software - im using the router 2600 pro.
is there a way i could stop the program and restart it tomorrow from its last position? the computyer will automatically if i leeve the pc it will automaticall shut down.
many thanks
Mark