Hi
I'm a newbie on the forum, i need to copy the offsets configuration off a laptop and on to other pc's so when VR Milling is loaded the files are already in place
Where do i find these files
Thanks
Config files and Toolsets location
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: Config files and Toolsets location
Is it VR Milling v2.xx or v5.xx ?
These posts may help anyway:
viewtopic.php?f=2&t=166
viewtopic.php?f=1&t=2970
In VRMilling2 they are probably stored in the files windmill.mol and windmill.mtd - you can open them in notepad to see if the numbers match the software.
These posts may help anyway:
viewtopic.php?f=2&t=166
viewtopic.php?f=1&t=2970
In VRMilling2 they are probably stored in the files windmill.mol and windmill.mtd - you can open them in notepad to see if the numbers match the software.
Re: Config files and Toolsets location
Its V5 and yes i think one of them post will help
many thanks
many thanks
Re: Config files and Toolsets location
There is a far simpler solution.
In the software that has the offsets with the offset window open and active go to the Offset/Tooling menu at the top of the screen.
Select advanced.
Go to the menu again and you can save the alloffsets.MOF file to any location (say a memory stick).
Then open the new PC, open the offset window and then the Offset/Tooling menu again. Now again select advanced the select Load all and browse for the offset file on the memory stick and all should then work!
In the software that has the offsets with the offset window open and active go to the Offset/Tooling menu at the top of the screen.
Select advanced.
Go to the menu again and you can save the alloffsets.MOF file to any location (say a memory stick).
Then open the new PC, open the offset window and then the Offset/Tooling menu again. Now again select advanced the select Load all and browse for the offset file on the memory stick and all should then work!