Page 1 of 1

Vr Milling slow feed rate and random cuts.

Posted: Thu 30 Jul , 2009 4:04 am
by MLeadbeatter
I am having problems with our Denford Microrouter compact using VR milling V5.28.0.467. Its feed rate slows done to 15% at times then does random cuts ruining the job. I also have a Microrouter running VR milling V5.28.0.467 which runns at the correct feed rate but does the occcassioal random cut half way throug some jobs. Any suggestions to fix our problems

Re: Vr Milling slow feed rate and random cuts.

Posted: Thu 30 Jul , 2009 8:29 am
by Denford Admin
The random cut problem sounds like an old issue we had with a certain version of Firmware:

Can you post pictures or read the label of the EPROM fitted close to the right of the 7-segment LED display inside the electrical boxes ?

See this post for machine/control identification
viewtopic.php?f=4&t=116

Re: Vr Milling slow feed rate and random cuts.

Posted: Fri 31 Jul , 2009 1:58 am
by MLeadbeatter
Mocrorouter compact serial number is E00482/3 if that is also any help

Re: Vr Milling slow feed rate and random cuts.

Posted: Fri 31 Jul , 2009 11:32 am
by Denford Admin
Ahh right - this is a different issue that we've had in the past - this is a firmware update you need via EasyUpgrade (not a new EPROM like I suspected):

Install EasyUpgrader from the V5 Milling CD and run that with the machine on and connected (with VR Milling shut down)
It will try to upgrade the firmware automatically once it finds the machine and connects ...