Page 1 of 1
Z axis "Asynchronous axis error" VR Milling Ver 2
Posted: Mon 20 Oct , 2008 9:56 am
by bradders
I keep getting a "Asynchronous axis error" on VR Milling Ver 2 and the Z axis will not home. This occurred after the Emergency Stop button was pressed and then reset?
Posted: Mon 20 Oct , 2008 9:57 am
by bradders
Could be a fault on the Z axis drive side of the control board. First I would install the latest ver of VR Milling ver 2 from out web site which is Ver 2.31
Posted: Mon 20 Oct , 2008 15:29 pm
by Denford Admin
I'd also power the machine off and back on again before re-connecting with VR Milling