Denford Software & Machines

Posted: **Wed 26 Apr , 2006 14:58 pm**

Where are the Offsets and Tooling library information stored on VR Milling Ver 5 ?

Posted: **Wed 26 Apr , 2006 14:59 pm**

C:\documentsandsettings\allusers\applicationdata\denford\alloffsets.MOF

Posted: **Wed 26 Apr , 2006 15:24 pm**

TIP
If you hover the mouse over the box at the bottom of the tool or offset pages, then it tells you where your tool file is coming from.

Posted: **Thu 27 Apr , 2006 8:49 am**

You can make a backup of the offset and tooling file to disc or hard drive that can be restored later.

With the offset window active a tooling and Offsets menu apears at on the top menu bar. If you select this there is a backup option.

Posted: **Mon 06 Dec , 2010 16:59 pm**

As an additional tip and because someone is asking:

Once you have located the file, you can open it in a Text editor like Notepad in order to quickly create pre-set offsets...

Open Notepad (Windows Start > RUN > Notepad)
Open the alloffsets.mof file and copy - paste new offsets in as shown:

: copy-pasting-offsets.jpg (46.35 KiB) Viewed 9385 times

By the way, I'm not sure this is quicker than using the offset editor in VR Milling 5...if you right click an offset, you can copy & paste the offsets numbers from one to another pretty quickly...

: copy-pasting-offsets2.jpg (34.77 KiB) Viewed 9385 times

Posted: **Wed 30 Nov , 2011 14:33 pm**

What about the Windows 7 path for the .MOF file ? is it c:\programdata\commonappdata\alloffsets.MOF ?

viewtopic.php?f=9&t=2894&hilit=programdata

Denford Software & Machines

Where are the Offsets and Tooling library information stored

Where are the Offsets and Tooling library information stored

Re: Where are the Offsets and Tooling library information stored

Re: Where are the Offsets and Tooling library information st