VR Milling v5.20 Released 28th Nov 2007

Submit any comments, issues or requests relating to the use of VR Milling Version 5 and 2

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

VR Milling v5.20 Released 28th Nov 2007

Post by Denford Admin » Wed 28 Nov , 2007 12:20 pm

Check here to download the latest version:

http://www.website.denford.ltd.uk/suppo ... -downloads

Changes in 5.20:
increased number of passes available to 15 on PCB import

change limit checks to not store the last position if you programmed a G92 Datum shift value - it was causing wrong out of limits errors

changes to scanning, to the use every figure when in microstepping mode

added second software limits, Travel_X2_pos from ini file: [Machine Capability] Travel2 X+=5 (COMMS_UseSecondLimits=49)

VMC1300 toolchanger added, config file changed to add second limits which activate with toolchanger fitted

changed basicmachine to not move the IV axis on a G28 - there is no need to and it was moving between sub prog calls.

Post Reply