Check here to download the latest version:
https://www.website.denford.ltd.uk/suppo ... -downloads
Changes in 5.20:
increased number of passes available to 15 on PCB import
change limit checks to not store the last position if you programmed a G92 Datum shift value - it was causing wrong out of limits errors
changes to scanning, to the use every figure when in microstepping mode
added second software limits, Travel_X2_pos from ini file: [Machine Capability] Travel2 X+=5 (COMMS_UseSecondLimits=49)
VMC1300 toolchanger added, config file changed to add second limits which activate with toolchanger fitted
changed basicmachine to not move the IV axis on a G28 - there is no need to and it was moving between sub prog calls.
VR Milling v5.20 Released 28th Nov 2007
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact: