Z axis "Asynchronous axis error" VR Milling Ver 2

Submit any comments, issues or requests relating to the use of VR Milling Version 5 and 2

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:
Contact bradders

Z axis "Asynchronous axis error" VR Milling Ver 2

Post by bradders » Mon 20 Oct , 2008 9:56 am

I keep getting a "Asynchronous axis error" on VR Milling Ver 2 and the Z axis will not home. This occurred after the Emergency Stop button was pressed and then reset?
Last edited by bradders on Mon 20 Oct , 2008 9:58 am, edited 2 times in total.
Top
User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:
Contact bradders

Post by bradders » Mon 20 Oct , 2008 9:57 am

Could be a fault on the Z axis drive side of the control board. First I would install the latest ver of VR Milling ver 2 from out web site which is Ver 2.31
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Mon 20 Oct , 2008 15:29 pm

I'd also power the machine off and back on again before re-connecting with VR Milling
Top
Post Reply

Return to “VR Milling - All Versions”