Submit any comments, issues or requests relating to the use of VR Milling Version 5 and 2
Moderators: Martin, Steve, Mr Magoo
-
joey1117
- Posts: 13
- Joined: Sat 18 Aug , 2007 21:09 pm
Post
by joey1117 » Fri 24 Aug , 2007 2:23 am
well i got the mill going it was one wire that was hooked to the c02 the wire was brock and now it WAS working good until i started putting it back together and i broke the prox switch on z
so what i need to know is it a normally open or a closed switch i know it is a two wire but any info you guys have on this will help me as the company i do work for has alot of these and i can get one easy enough if i know what to get please help it is so close to going i cant wait
thanks
joe
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
- Location: Sunny Brighouse
-
Contact:
Post
by Denford Admin » Tue 28 Aug , 2007 9:52 am
Sorry - have asked around here and we can't be sure.
Even if we found a drawing, I still wouldn't be 100% about it being PNP or NPN as its changed so many times over the years.
Could you just fit a manual switch temporarily in place of the proxy, and see which way it homes with the switch open or closed.
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
- Location: Sunny Brighouse
-
Contact:
Post
by Denford Admin » Wed 29 Aug , 2007 9:03 am
Excellent - I'm glad someone has a good memory
