How to change the tooling and offset file location - v5

Submit any comments, issues or requests relating to the use of VR Milling Version 5 and 2

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

How to change the tooling and offset file location - v5

Post by Denford Admin » Mon 21 May , 2007 13:37 pm

How do I change the location of the alloffsets.mof file from its default location in VR Milling version v5 ?

Some networks are restricted and will not allow the default file to be edited...
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Mon 21 May , 2007 13:40 pm

Open the work offset editor - the Offsets / Tooling menu should now appear on the top menu bar as shown.

Select the option "Save As..." and save the offsets file to a location on the network, which you have read / write permissions
Attachments
offsets-save-as.gif
offsets-save-as.gif (11.01 KiB) Viewed 4360 times
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Mon 21 May , 2007 13:43 pm

Now, to make VR Milling use this file, select the "Advanced" menu option and click "Load All" which will have now appeared....
Now choose the .MOF file you saved previously
Attachments
offsets-load-all.gif
offsets-load-all.gif (4.9 KiB) Viewed 4359 times
Top
Post Reply

Return to “VR Milling - All Versions”