Trouble Shooting VR Milling/Turning RS232 Comms Problems

Submit any comments, issues or requests relating to the use of VR Milling Version 5 and 2

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:
Contact bradders

Trouble Shooting VR Milling/Turning RS232 Comms Problems

Post by bradders » Tue 13 Mar , 2007 8:40 am

Is there a step by step guide to "Trouble Shooting VR Milling/Turning RS232 Comms Problems"?
Last edited by bradders on Tue 13 Mar , 2007 8:43 am, edited 1 time in total.
Top
User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:
Contact bradders

Post by bradders » Tue 13 Mar , 2007 8:42 am

Download / view this document
Attachments
Communication Troubleshooting with VR software.pdf
(76.32 KiB) Downloaded 1376 times
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Tue 13 Mar , 2007 13:08 pm

NB, this is an oldish document and refers to Version 2 milling and RS232 problems only - see elsewhere for USB issues

The Current machines and version 5 Milling use the USB interface and different Control Hardware / Firmware
Top
Post Reply

Return to “VR Milling - All Versions”