Good afternoon,
i have started a rather long program on the VR milling V5 software - im using the router 2600 pro.
is there a way i could stop the program and restart it tomorrow from its last position? the computyer will automatically if i leeve the pc it will automaticall shut down.
many thanks
Mark
starting a milling program from its mid point
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: starting a milling program from its mid point
Use block search - might be best to familiarise yourself with it before doing it for "real" !
- Attachments
-
- block-search.jpg (263.74 KiB) Viewed 5271 times