Nakamura Post using Featurcam

Anything to do with configuring CAM systems and Post Processors to run on different CNC machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
PeterO
Posts: 2
Joined: Tue 04 Sep , 2012 13:26 pm
Hardware/Software: Featurecam

Nakamura Post using Featurcam

Post by PeterO » Wed 05 Sep , 2012 9:09 am

Hi from Australia.
Can anyone point me in a direction for a Post.
We are using Featurcam version 2009
Nakamura-Tome lathe.
Front cover of the instruction manual reads:
TMC15/15M and TMC20/20L
With Backface turning device
Edition : 04
B-1176BE/04
B-1276BE/04
1992-06
It has a Fenuc Series 13-T controller

Any help would be greatly appreciated.

Best Regards Peter O

User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Re: Nakamura Post using Featurcam

Post by Denford Admin » Wed 05 Sep , 2012 10:13 am

Sorry Peter but none of those products we have any knowledge of.
You're probably best joining up and posting on CNCZone if you haven't already.

Post Reply