Hi from Australia.
Can anyone point me in a direction for a Post.
We are using Featurcam version 2009
Nakamura-Tome lathe.
Front cover of the instruction manual reads:
TMC15/15M and TMC20/20L
With Backface turning device
Edition : 04
B-1176BE/04
B-1276BE/04
1992-06
It has a Fenuc Series 13-T controller
Any help would be greatly appreciated.
Best Regards Peter O
Nakamura Post using Featurcam
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: Nakamura Post using Featurcam
Sorry Peter but none of those products we have any knowledge of.
You're probably best joining up and posting on CNCZone if you haven't already.
You're probably best joining up and posting on CNCZone if you haven't already.