Post Processors - Shopbot

Anything to do with configuring CAM systems and Post Processors to run on different CNC machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
Benny
CNC Expert
CNC Expert
Posts: 201
Joined: Fri 20 Oct , 2006 15:27 pm
Location: USA

Post Processors - Shopbot

Post by Benny » Thu 29 Nov , 2007 15:32 pm

Customer writes: I have QuickCAM 3D and I have a shopbot cnc router that I was hoping you would have a post for. I am involved in F1 in Schools Challenge. If not I believe I can import a standard G code file with the software that I have. I am hoping you can help. Thank you.
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Thu 06 Dec , 2007 12:09 pm

If the file format is fairly generic, then a post can be done quite quickly.

We just need an example program, what the program is (eg, a box 60mm by 80mm and two arcs: 90deg 52mmRadius, 220deg 43mm radius)
Top
Post Reply

Return to “Post Processors”