Light Machines - Post Processor

Anything to do with configuring CAM systems and Post Processors to run on different CNC machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
Benny
CNC Expert
CNC Expert
Posts: 201
Joined: Fri 20 Oct , 2006 15:27 pm
Location: USA

Light Machines - Post Processor

Post by Benny » Tue 20 May , 2008 18:50 pm

I need help in getting a post file that will run on our Light Machines educational mill.
the Larken Camtool post does not work...although the G-code looks vary similar...the light machines will not read how the tooling information is written.

I have attached a sample engraving file of a snowflake from the Light Machines Mill software. Perhaps that can help you figure out a post file for the Light Machines mill.

thanks, -OV-
Attachments
flake2006fix.zip
(5.07 KiB) Downloaded 979 times
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Wed 21 May , 2008 10:44 am

Hi,

Can you try this file out on the proLight please ?

It should be nearer to what you need...
Attachments
proLight.zip
(2.87 KiB) Downloaded 1048 times
Top
Post Reply

Return to “Post Processors”