BobCAD Which Post to use with VR Milling VR Turning

[JSKRABA]

I am considering using BobCAD with VR Milling 2.3 and VR Turning
Does any one know which of the many posts that BobCAD/Cam has is best?

Does any one from Denford Support have an idea how I might know, is there a spec I could use.

[Denford Admin]

This post should help if you need to create your own.
Start with a basic Fanuc 0M or 0T post and try not to use Cycles (ie, have Bobcad expand cycles into G01,G02 and G03's)

[Croy]

if you post a request on BobCad site they will respond and answer you.

[Denford Admin]

This post should help if you need to create your own.
Start with a basic Fanuc 0M or 0T post and try not to use Cycles (ie, have Bobcad expand cycles into G01,G02 and G03's)

Sotty, I meant to link to this post:
viewtopic.php?f=16&t=1370