Page 1 of 1
Micromill electrical diagrams ?
Posted: Sun 06 Dec , 2009 22:08 pm
by A.PENNOCK
Has anyone out there got a wiring diagram for the micromill please?
Re: Micromill
Posted: Sun 06 Dec , 2009 22:31 pm
by Steve
What is the age of the machine?
Where are you located?
Do you have a problem with it?
Re: Micromill
Posted: Sun 06 Dec , 2009 22:46 pm
by A.PENNOCK
Unshure of its age but the main circit board was produced by:
OPTIMISED CONTROL LIMITED
BRISTOL
D771 ISSUE 2
4202
The previouse owner decided to take all the wires out to convert it to mac i have identified the stepper motors but i want to get the speed controll working i am in county Cleveland
Re: Micromill
Posted: Mon 07 Dec , 2009 9:48 am
by Steve
Could you take a photo of the electrical panel?
Re: Micromill
Posted: Mon 07 Dec , 2009 21:06 pm
by A.PENNOCK
- DSCF0650.JPG (76.56 KiB) Viewed 14636 times
Re: Micromill
Posted: Tue 08 Dec , 2009 10:16 am
by Denford Admin
Hopefully these drawings will give you enough info...
viewtopic.php?f=15&t=2495
Re: Micromill
Posted: Tue 08 Dec , 2009 11:23 am
by Steve
Hi,
The board you have is earlier than anything I have drawings for.
I suspect it would be a very basic circuit.
I attach a diagram for a smart step which was the following generation machine.