DOS Micromill manual (inc. how to use without Tutor keypad)
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
DOS Micromill manual (inc. how to use without Tutor keypad)
Because the USA didn't take Tutor keypads, this user manual for the DOS software tells you how to use it without one on a QWERTY keyboard (eg ALT-H for home etc..)
- Attachments
-
- Micromill-USA-DOS-Manual.pdf
- (2.59 MiB) Downloaded 1565 times