More old machine software found PLUS Photos and Drawings
Posted: Fri 12 May , 2006 9:23 am
https://www.denfordata.com/downloads/dos ... FTWARE.zip
This ZIP file contains...
EASIMILL - Software for Easimill machines fitted with a PNC3 controller
EASITURN - Software for Easiturn machines fitted with a PNC3 controller
ORAC - Software for Orac'85 machines (will not work with older oracs macnufactured before 1985)
QUATRO - Software for Easimill machines fitted with a PNC4 controller
STARMILL - Software for Starmill non-ATC machines fitted with an SMCU controller
STARM-TC - Software for Starmill ATC machines fitted with an SMCU controller
TRIAC - Software for Triac machines fitted with a PNC3 controller
STARTURN - Software for Starturn machines fitted with a GSM controller
I found the above packages in an old software archive and have not been tested.
They seem to run OK but crash my XP machines when I try to run a simulation so I guess they are best run from outside of a windows environment (try to find an old DOS machine, or and old Windows 98 machine and reboot in DOS mode). I haven't tested any of the machine links either as I do not have access to any hardware so all of the above comes with no guarantees, but I hope it is of some use to some of you guys trying to get your old hardware up and running again.
Take a look inside these folders for pictures of the machines and cable diagrams
Regards...
Mr Magoo