Denford Software & Machines

Posted: **Thu 05 Feb , 2009 17:54 pm**

I have a Vicerory T.D.S.1/1 GB and i'm desperately in need of a crosslide screwnut. has anyone a secondhand or a wornout nut? that I could use as a pattern, or even a drawing, that I could make a new one the thread is 1/2 inch x 10 tpi, acme Spanner 10

Posted: **Tue 10 Feb , 2009 21:29 pm**

see www.tracytools.com think sell them taps

Posted: **Sun 15 Feb , 2009 17:45 pm**

What does the 'spanner 10' refer to?

Posted: **Sun 15 Feb , 2009 19:11 pm**

SEE THIS viewtopic.php?t=1918&highlight=280

Denford Software & Machines

crosside screw for viceroy tds1/1g.b.

crosside screw for viceroy tds1/1g.b.