Eliptical Curve on Lathe

Read what other Denford users are doing with their machines and software.
Educational resources, ideas and courseware.
If you have a Denford related success story, please tell us about it here.

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
boots
CNC Expert
CNC Expert
Posts: 220
Joined: Tue 16 Jan , 2007 21:22 pm

Eliptical Curve on Lathe

Post by boots » Thu 08 Mar , 2007 18:56 pm

Is there a way to program an eliptcal curve on a Microturn.
We plan on doing pens and want to do a partial eliptical curve not just a taper or radius. Is there a G Code for this? or is this written code?
Thank you
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Fri 09 Mar , 2007 10:44 am

I don't know of any G code which would produce a curve.

I would stick to drawing it with arcs - a series of joined arcs can give the same effect as an ellipse or curve.
I'm sure Steve has some lathe pen examples - I'll ask him to post them up here
Top
Post Reply

Return to “User Stories / Projects / Courseware”