Microscope adapter

Read what other Denford users are doing with their machines and software.
Educational resources, ideas and courseware.
If you have a Denford related success story, please tell us about it here.

Moderators: Martin, bradders, Steve, Mr Magoo

Post Reply
User avatar
dazz
CNC Expert
CNC Expert
Posts: 238
Joined: Sat 19 Aug , 2006 11:31 am
Hardware/Software: Viceroy TDS 1/1GB lathe, Imperial, stripped down and rebuilt.
Viceroy Taper/Tracer attachment, Shop made cross slide tracer attachment, VSD.
Location: New Zealand

Microscope adapter

Post by dazz » Tue 05 Oct , 2021 21:44 pm

Hi
I purchased a Bausch & Lomb Stereo Zoom 4 microscope from ebay USA. This is for electronics, which use parts small enough to require a microscope to work with.

To reduce shipping cost, I found a microscope with a mount but no stand. The plan was to buy a computer monitor stand and make an adapter.

Although some surfaces were machined on a mill, most operations were completed on the lathe.
Attachments
IMG_0929.JPG
A close up of the adapter
IMG_0929.JPG (237.95 KiB) Viewed 465 times
IMG_0926.JPG
The complete monitor stand, adapter and microscope
IMG_0926.JPG (193.05 KiB) Viewed 465 times
Regards

Dazz

Post Reply