We have a Sanyo monitor suitable for old Triacs.
It is marked as Faulty as of 1998, so the tube could well be in good condition with little burn out (if it works)
Free to anyone willing to pay postage costs (15 to 20GBP I would guess)
Triac Sanyo monitor for spares / repair
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Triac Sanyo monitor for spares / repair
- Attachments
-
- Triac monitor
- triac-monitor.jpg (23.29 KiB) Viewed 5461 times
Re: Triac Sanyo monitor for spares / repair
Is the sanyo monitor still available?
Denford Admin wrote:We have a Sanyo monitor suitable for old Triacs.
It is marked as Faulty as of 1998, so the tube could well be in good condition with little burn out (if it works)
Free to anyone willing to pay postage costs (15 to 20GBP I would guess)
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
This one is yes - just had a closer look and it doesn't have a connector on the back (cable has been chopped off) - it would probably be only good for spares or repair of an existing monitor .
The tube may be good, and the chassis / case are ok condition
If you don't already have a monitor at all, then I would think this would be a long shot solution
The tube may be good, and the chassis / case are ok condition
If you don't already have a monitor at all, then I would think this would be a long shot solution