Denford TRIAC ATC .... Needs a home
This machine was purchased with the prospect of getting a young family member into the Engineering scene.
The control was taken off with the outlook of using flashcut or mach3.
To get this working you will need stepper motor drivers, and a control system + alittle time to wire it up.
Mach3 should even drive the tool changer ! … some spindle tooling also.
SENSIBLE offers considered!
The machine is located north Derbyshire
Denford TRIAC ATC .... Needs a home
Moderators: Martin, Steve, Mr Magoo
Triac w/ ATC
I have a 1985 Triac that could use a twin for upgrade parts/modernization. What spindle does yours have? I would love to find out more about the one you are offering. Perhaps I could purchase it and sell mine, since yours sounds more modern. I do not mind that the controls are missing, since I was planning to update either way. Does it still have the spindle motor and driver? Hope to hear from you soon. Thank you in advance for any response you may provide.