Viceroy tds top slide

[Tally47]

Hi folks, the top slide casting has broken on my Viceroy tds lathe where the tool holder fits.
Does anyone have one for sale? Or any experience in making a new one?
Is it possible to fit something from a different machine?
Thanks

[Pete.]

If it's the upturned taper cone that's broken away you could effect a temporary repair by drilling through and bolting from below with countersunk screws, unless it's torn a hole. My first lathe was an atlas that has been crashed and repaired in this fashion. It was still like it when I sold it on.

[Minijamie32]

Hi I'm missing the cog that connects the wheel handle to move the slide left to right can anyone help with size, number of teeth ect. Picture and / or sizes so I could get one made. See pictures attached. Hope this makes sence.
Thanks Jamie