all the hard work done, its wiring (tidy) has been converted to run either Mach3 or UCCNC - just needs the ATC building back up as it was full of solid grease.
Software would need to be configured for whichever control you wanted to use but options for either are there.
UC300ETH-MAX Controller from CNCroom.com
Two new inverters, one for spindle & one for tool post
New British spindle encoder 360ppm
Pneumatic Chuck & Pneumatic guards open/close of buttons now rather than M codes
Its hardly done any work and inside the machine is in very good condition - outside it has some wear and marks but i was just going to give it a freshen up.
all wiring has been traced from original diagrams and all matched by original numbers (tags still present) where possible so its easy to see what's going on
drop me a message with you email and I'll fire some pictures across or ebay link below
looking for £2000 or offers
https://rover.ebay.com/rover/1/710-53481 ... olid=11111