I have a Denford 30 day training program. It has a part 1 and part 2 book (for the students). I am missing the full part one book. Does anyone have one?
Also did this particular material have Disk's with it? My 10 day training has several disk's with it. Not sure if the 30 day one is software driven, or strictly book work. Thank you
Denford 30 day training program
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: Denford 30 day training program
Are you in the USA ?
Is this milling or turning ? Which software is it based around eg, Millcam and VR Milling v2? or QuickCAM and VRMilling 5 ?
We may be able to resupply by emailing a .pdf
Is this milling or turning ? Which software is it based around eg, Millcam and VR Milling v2? or QuickCAM and VRMilling 5 ?
We may be able to resupply by emailing a .pdf
Re: Denford 30 day training program
I am in the USA.
This is for Milling. We have a Micromill 2000. I am using VR 2.3.something to run the machine.
Looking for something to keep the students busy for a bit longer till I get my act together.
I am missing the full part 1 manual (the one the students use). I have the full Part 2 and the instructors manual for both.
This is for Milling. We have a Micromill 2000. I am using VR 2.3.something to run the machine.
Looking for something to keep the students busy for a bit longer till I get my act together.
I am missing the full part 1 manual (the one the students use). I have the full Part 2 and the instructors manual for both.
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: Denford 30 day training program
Jeff,
I've tried to reply to your recent email, but they are being rejected:
I've tried to reply to your recent email, but they are being rejected:
The destination server for this recipient could not be found in Domain Name Service (DNS). Please verify the email address and retry. If that fails, contact your administrator.