Viceroy TDS 1/2 PCS Change Wheels

[riley]

I would like to increase the useability of my lathe by obtaining a set of change wheels suitable for screw cutting.

According to the screw thread chart, located on the inside of headstock door, I appear to be missing the following gears:

16T; 20T; 24T; 32T (x2); 4OT; 44T and 80T.

There is also some damage to the 100T gear change wheel so I would also like to get hold of a replacement for this.

If anyone has any of these gears as spares, or knows of a suitable supplier, Iwould appreciae hearing rom them

Thanks

Bob

[Pete.]

My changewheels are stored on a bolt inside the cover. Are you sure they are not there but you haven't noticed them?

[riley]

Hi Pete,

Thanks for the reply and the information.

I had noticed this facility in a lathes.co.uk article but it is not installed on the particular model that I have in my possesion.

Perhaps I have an earlier model or something and the gears were supplied loose!

I have managed to track down the 44T and the 80T but still looking for the others.

Bob

[Pete.]

Bede tools broke up a denford a few months ago Bob, can't remember the model but they might have them.

Pete.

[riley]

Thanks for the info Pete.

The set I needed had already been sold. They just have the odd one or two left.

Bob