William Woolard presents the Denford Orac + Video

If you've had enough of reading, then look at these pictures of the "good" old days. Machine brochures, magazines etc..

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

William Woolard presents the Denford Orac + Video

Post by Denford Admin » Fri 16 Jul , 2010 8:47 am

Found this pic while rooting around...
Orac-William-Woolard.jpg
Orac-William-Woolard.jpg (37.22 KiB) Viewed 19000 times

Then found the videos already on YouTube!
orac-you-tube.jpg
orac-you-tube.jpg (37.49 KiB) Viewed 18999 times
https://www.youtube.com/watch?v=QV1bQeJ9tx4 (Part 1)
https://www.youtube.com/watch?v=K0qbzCkkYA8 (Part 2)
Top
User avatar
Mr Magoo
CNC Guru
CNC Guru
Posts: 301
Joined: Tue 21 Feb , 2006 21:45 pm
Location: Brisbane, Australia

Re: William Woolard presents the Denford Orac + Video

Post by Mr Magoo » Mon 22 Nov , 2010 22:39 pm

This used to be played to everyone who came on a Denford training course. Is it sad that I still knew half of the script off by heart!
Can anyone dig out the CIM video too? Another cracker!
Top
Post Reply

Return to “Vintage Pictures”