LaserCAM 1.4 crashes when trying to run
Posted: Wed 14 Feb , 2007 15:05 pm
We have had a few instances where LaserCAM 1.4 is installed and crashes as soon as you try to run it.
As we don't have any problems with the LaserCAM software on any of our computers here, we can only guess as to the cause of this (any feedback would be much appreciated - we can't fix something thats OK for us)
Its possible that some original CD's have been corrupt / badly created - try downloading the CD image zip from our downloads section on www.denford.co.uk
Does turning graphics hardware acceleration off help at all ?
Is there any other Denford software installed on the PC ?
Has any Denford software been installed, and removed ?
There are common files which could get removed by one of our pieces of software, and still be required by another
OK - We have found the problem now, and its fixed in LaserCAM version 1.5 onwards