Page 1 of 1
Quick CAM 2D Design
Posted: Tue 19 Dec , 2006 17:09 pm
by arossner
Does anyone know how to alter the Datum? I have a part that I would like to run and have the Datum location right in the Top Center of the billet. How do I reset the Datum to this new location?
Posted: Tue 19 Dec , 2006 22:04 pm
by Denford Admin
The easiest way is to design around the bottom left corner of the page, which is the fixed 0,0 Datum postition.
Although the toolpath will go outside the 'page', it dosn't matter, they will still be created in the CAM wizard.
A picture paints a thousand words .....