Sometimes when I import my CAD file it turns the arcs into hundreds of little lines about 0.3mm apart. Not normally a problem with a modern machine but my old machine stops between each line of code, and has a tiny memory so this can be a huge problem.
I only work with lines and arcs to keep memory down and most of the time it works fine.
They are arcs in the CAD file, and look like arcs in QuickCAM, but when it outputs the machine file its a spline?
How can I stop it doing this?
Matt
Site Admin
QuickCAM will break everything down to lines when calculating the toolpath.
If you have the option to convert back to arcs on, then it will do its best to turn the lines back into arcs when posting the g-code.
Even if the shape was a spline, it should still be able to create arcs at certain points.
If you have the option to convert back to arcs on, then it will do its best to turn the lines back into arcs when posting the g-code.
Even if the shape was a spline, it should still be able to create arcs at certain points.
Attachments:
- The convert output to arcs option menu
- quickcam-2d-output-arcs-menu.gif (1.7 KiB) Viewed 11286 times