quickcam 2d design post processor
Moderators: Martin, Steve, Mr Magoo
quickcam 2d design post processor
Hello,
Is it possible to post for a mitsubishi meldas control from quickcam 2D design?
Thanks
Is it possible to post for a mitsubishi meldas control from quickcam 2D design?
Thanks
- Denford Admin
- Site Admin
- Posts: 3642
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
- Denford Admin
- Site Admin
- Posts: 3642
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Its a totally different system used in the new post files.
The old one that included an Heidenhain post is based on a 16-bit and would have taken us years to update, therefore we have gone for a much simpler way of changing the output.
A basic Heidenhain shouldn't be too much of a problem (I think) in any case you could always run the Heidnhain in ISO mode instead of dialogue, and the basic G code posts will work (with a bit of tweaking)
The old one that included an Heidenhain post is based on a 16-bit and would have taken us years to update, therefore we have gone for a much simpler way of changing the output.
A basic Heidenhain shouldn't be too much of a problem (I think) in any case you could always run the Heidnhain in ISO mode instead of dialogue, and the basic G code posts will work (with a bit of tweaking)
- Denford Admin
- Site Admin
- Posts: 3642
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact: