QuickCAM 2D v2.11 and LaserCAM 2D v2.9 released 12th April 2024
LaserCAM and QuickCAM are resistant if an image file is uploaded which does not contain any image data. Previously it would crash. Now it just shows the image as blank.
The minimum speed of the post processor simulation has been drastically reduced. With moden technology, even the slowest speed was too fast. Its now been slowed down considerably.
The DXF import of LaserCAM has also been improved and can cope with much more modern DXFs.
As usual - check here for the latest version:
https://denford.co.uk/software-downloads-support/
QuickCAM 2D v2.11 and LaserCAM 2D v2.9 released 12th April 2024
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3635
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact: