LaserCAM 1.4 crashes when trying to run
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
LaserCAM 1.4 crashes when trying to run
We have had a few instances where LaserCAM 1.4 is installed and crashes as soon as you try to run it.
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
As we don't have any problems with the LaserCAM software on any of our computers here, we can only guess as to the cause of this (any feedback would be much appreciated - we can't fix something thats OK for us)
Its possible that some original CD's have been corrupt / badly created - try downloading the CD image zip from our downloads section on www.denford.co.uk
Does turning graphics hardware acceleration off help at all ?
Is there any other Denford software installed on the PC ?
Has any Denford software been installed, and removed ?
There are common files which could get removed by one of our pieces of software, and still be required by another
Its possible that some original CD's have been corrupt / badly created - try downloading the CD image zip from our downloads section on www.denford.co.uk
Does turning graphics hardware acceleration off help at all ?
Is there any other Denford software installed on the PC ?
Has any Denford software been installed, and removed ?
There are common files which could get removed by one of our pieces of software, and still be required by another
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
OK - We have found the problem now, and its fixed in LaserCAM version 1.5 onwardsGet the latest version from our website downloads page here:
https://www.website.denford.ltd.uk/suppo ... -downloads