Arcs being generated the wrong way round
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Arcs being generated the wrong way round
We are using v1.3 of quickcam 2D and the arcs are being output the wrong way round occasionally - eg, a CW arc is being change to a CCW arc.
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
We have found that this problem is related to AMD64 processors storing numbers slightly differently.
It has now been fixed, and will be released shortly in v1.4 - this also goes for LaserCAM 2D.
In the meantime the problem can be fixed by turning off the option to convert lines to arcs (Menu -> Generate -> Convert Output To Arcs)
It has now been fixed, and will be released shortly in v1.4 - this also goes for LaserCAM 2D.
In the meantime the problem can be fixed by turning off the option to convert lines to arcs (Menu -> Generate -> Convert Output To Arcs)