Search found 6 matches

Hi,

As Per title, I think my boot disk has given up the ghost as my machine will not boot up due to not being able to read the disk. I've chaged the drive but it made no difference so I now need to try another disk.

Since I don't have an old enough PC to make a compatible boot disk I wondered if ...

Hi,

As per title, I have a Denford Mirac which appears to have a faulty Spindle Drive, it was working fine until it was left during the bad weather as I was unable to get to my workshop. After re-starting the machine it would not rotate the chuck or the the toolpost. Spindle Drive shows error EUP ...

Hi again,

Sorry for the delay in getting back to you......That does look like the correct turret, I'll have a closer look at the downloaded drawing and see what parts I might need.

Many Thanks for your help!

Gary

Hi again,

Thanks for the info, that does sound exactly like what I have, with the O ring seal, etc.

I took the rotation sensor to bits (not recommended for people with big hands, very fiddly!), cleaned all of the contacts for each of the tool positions and put it back together again. I adjusted ...

Hi again,

There are no name plates on the Turret but it has a red painted square block below the drive motor with a large Machined 2-piece Aluminum Housing behind it which has the Rotation Sensor in it. I had been told that it may have been a turret manufactured by yourselves. I can check more ...

Hi there.

I hope someone can give me some tips with this! I have a 1994 Mirac with the 8 Station Tool Turret which I bought from my old College when they stopped their engineering courses. A few weeks ago it developed a problem where it changes to the wrong tool (e.g. loads tool 6 instead of 7) but ...