You're (mostly) in luck again! Posted at the bottom of this thread - https://www.denfordata.com/bb/viewtopic.php?f=50&t=2941&p=22986#p22986 I think ML 100/800A - 2way Toolpost may have been superseded by ML119. I don't think I've got any of the small size standard parts (SP) drawings - but that lev...

ML 100 500 general arrangement drawing has a section and plan of the single toolpost, in sufficient detail that with a little judicious scaling off the drawing it should be possible to make one. Drg BVS 100 500, for the 280 Synchro model has a cross section through the 2 way toolpost as well. Richa...

Good day, In my journey to restore my old Viceroy TDS 1 lathe this is the next subject that requires attention, the toolpost. Is the following drawings available? I did a search on the forum but nothing turned up. Relevant arrangement/assembly drawings: ML 100/800 - Single way Toolpost (I did find a...

Andy B wrote: ↑

Wed 03 Apr , 2019 21:14 pm

De-El wrote: ↑

Wed 03 Apr , 2019 20:14 pm

I did go through the pack of scans already, unfortunately ML105/403 is not in there.

Yes it is - on page 23.
It must have been out of sequence when the pile was scanned - between ML105/306 and ML105/307.

Andy

Oops, sorry I didn't notice that, I see it is there yes.

Thank you.
D

Leadscrew drawings now uploaded in this thread - https://www.denfordata.com/bb/viewtopic.php?f=50&t=2941&p=22970#p22970 Collar drawing was already uploaded in this pack of scans - https://www.denfordata.com/downloads/forum/ML105%20ML110%20scans.pdf If anyone wants to produce a list of the drawings ...

Richard

ML 105/402 is the 'English'-thread Leadscrew
ML 105/402C is the Metric-thread Leadscrew

ML 105/403 is the Leadscrew collar

Regards
D

Good day,

I posted this over in the downloads section.
viewtopic.php?f=15&t=5707
Just linking to it from here hoping to find the info I am after.

Regards
D

Good day, I am a new owner of a TDS 1 LS. It dates from around the 60's and was used in a school but was in storage for quite some time. Sadly some parts has gone missing over the years. I will be stripping it down, rebuilding and restoring it to its former glory for use in my workshop. For the mome...