Unfortunately i do not have much paper work explaining much.

Do you know of anyone or a number i could call to pay for someone to come and have a look at this for me?
I am in Southampton UK.

Thanks in advanced.

i dont think i do but will have a dig though it to be sure .

Unfortunately no, they are not labelled?

Fuse seems ok and board is fully pushed, your right, there is a cable tie holding it back as well.

Pictures attached of lights...

Pictures attached, hopefully you can see them!

The toolpost i have is Baruffaldi RH 80- 6

Even with the toolpost connected it comes up with an alarm, can the thermal sensor fail?
Or is there a trip i do not know about?

Thanks.

Thanks for you help!

I have just tried this as it is 0 at the minute.
Every time i try and change it, it automatically defaults back to 0.

Do you know what could be making this happen?

Thanks for your help!
All parameters are restored, however unfortunately it still gives me a warning of 'Tool post overheat' even when the tool post isn't plugged in...

Any help would be greatly appreciated as this is my only lathe and starting to loose work now :'(

Thank you in advanced!!

Does anyone have diagnostic parameters for 1989 cyclone serial number CY03118B Like a fool i managed to delete all parameters!! I have managed to re install Standard parameter set but cannot find anything on the diagnostic side... Does anyone have more information on this and any advice? Thank you i...