Sold!

Hi I am selling my Myford Orac. It is located in Norway. It is 100% original from what I know, but I have problem moving it in z and x axis. I will accept 1150£ + shipping costs etc. For detail about the problem see link: https://www.denfordata.com/bb/viewtopic.php?f=43&t=4746 email: amo_760@hotmail...

Here is a picture of four red ligths that turn on. I guess they are indicating a failure?

Hi

I have tried the reset button. I will se over the electronic and check fuses and se for damaged component/cable. That's at least a start

Hi

I have seperated the lathe and taken some pictures

Hi

So you mean that I need to lift off the lathe with bed from the electronic base below?

Hi

2 x SD3 driver boards

Hi

I have never used this lathe before, I bougth it this spring together with a Triac mill and was told that it was in working condition. The mill works like it should, maybe the seller didn't know about this fault or it appeared after I received it?

Where is the supply voltage for the drivers?

More pictures

Here are some pictures. I can take better and more pictures, but maybe it's good enough?

Hi

The fuse that breaks is 4A 240V

Hi I have problems with my Denford Orac 1985. I can not move it in Z and X. X axis a manages to get motion once, but Z axis will never move. The SD3 card next to the monitor have two fuses and one off this breaks every time a start up the machine. I have replaced it 4 times. I switched SD3 cards to ...