Hi All

Got the motors now running at full speed by disconnecting the tach wires on pins 1 and 2 of the drive. Any idea what may be causing this?

Really appreciate some feedback.

Cheers
Mick

NORWIN DRIVE MANUAL 1.pdf Hi All Recently started a conversion on my Denford Senior Lathe. I am using the CSMIO/P-A motion controller by CS Labs. I have the drives powered up and enabled. Can anyone explain in simple terms the easiest way to turn the drives prior to PID tuning in the motion control...

Screenshot (46).png Hi all Looking to convert my Denford Senior which has a Fanuc OT control to Mach3 using a CSMIO/IP-A Ethernet Motion Controller (+/- 10V). I was hoping to use the existing Sem motors and Norwin drives. It looks to me like the drives need +/- 15v to control the motors. All the av...

Hi All Finally got my Senior 200 up and running with a massive help from Martin which is well appreciated. Can anyone please advise on this issue I seem to be having setting the tool offsets. I have followed the manual but when I do a tool change the z axis is out. This is how I have set it using 43...

Hi All
Finally got round to powering up a Denford Senior 200 that I have had sitting around now for 12 months. All powers up ok but I have a (NOT READY and an alarm 510 over travel).
Would really appreciate any help. The machine is 1990 with a fanuc ot control.

Cheers all
Mick

Hi There
Thanks for your reply. Its a Denford senior 200 1990 with 8 station turret. I am not picking the machine up until Saturday so will be able to provide a serial number then if needed. Are the parameters different between serial numbers? I thought that model would all be the same??

Thanks
Mick

Hi Everyone
I have just purchased a Denford senior 200 with fanuc ot control built 1990. Would anyone happen to have the original parameters for this machine. I have been told that because the machine has not been used that the battery may have gone flat and lost its setting?

Many Thanks
Michael